The electromechanical of Cymbal transducer has been researched. 研究了Cymbal换能器的力电性能。
The Basic Research of Double-Rotor Electromechanical Energy Transducer 双转子机电能量变换器的基础研究
Study on Material Constants and Electromechanical Characteristics of Cymbal Transducer Cymbal换能器的材料常数与机电性能关系研究
Electromechanical Integrating Design for the Float Type Level Transducer With Wide Range and High Resolution 大量程高分辨率浮子式液位传感器的机电一体化设计
According to the electromechanical transfer equivalent figure of piezoelectric vibrator, the piezoelectric transducer is equivalently expressed as a two-port device and the two-way transduce function is deduced. 根据压电振子机电换能等效图,得出压电超声换能器等效二端口网络模型,由此推导了智能结构中压电换能器的双向换能函数。
Research on Structure Parameters and Electromechanical Characteristics of Cymbal Transducer Cymbal换能器结构参数与机电性能的研究
The design strategy for the electromechanical integrating transducer is discussed in there areas. Some issues, i.e. using contacting shaft angle encoder as the A/ D converting part; using single chip computer for implementing data correction on the encoder and converting parallel output to serial output; 从三个方面对机电一体化传感器方案设计进行讨论,详细介绍采用接触式轴角编码器作为A/D转换部件,采用单片机实现编码器数据修正、并行转串行输出,传感器与上位机的通信联网等问题。
An Efficient Method of Measuring the Electromechanical Coupling Factors of Piezoelectric Transducer Slices 测定压电换能片机电藕合系数的一种有效方法
This paper attempts to describe the theoretical model of SSA. Based on the theory of bilateral electromechanical transducer, SSA is modeled by transfer matrixes of bilateral transducers. 基于双向换能器理论,利用机电双向换能器的传输矩阵,建立了自感知执行器数学模型。
This paper analyzes the equivalent electromechanical model of the ultrasonic vibration system made up of a longitudinal composite bar high_power transducer, a horn and a scalper, and presents the vibration amplitude control approach based on the self_modifying PID fuzzy controller for the power ultrasonic medical instrument. 首先分析了纵向复合棒大功率换能器加接刀具的振动系统的等效机电模型,根据等效机电模型提出了一种基于自调整PID模糊控制器的功率超声设备振幅控制方法。
Electromechanical equation of piezoelectric crystal stack is derived from the piezoelectric equations of constant D and constant stress, but the acoustic speed of under the constant E is used in design in practical transducer design. 推导晶堆的机电状态方程时,选用的是恒定电位移及恒定应力时的压电方程,最后设计计算时却又用的是恒定电场下的声速。
The parallel plate electromechanical transducer of lumped-parameter devices is studied first in the paper. 文章首先研究了集总参数的平行板机电换能器。
Using electromechanical coupling energy, elastic energy and dielectric energy, the electromechanical coupling factor of the transducer is obtained. 用换能器内的机电耦合能、弹性能和电能求得换能器的机电耦台系数。